How to Connect AC Tubing to Hybrid Nest?

Discussion and information relating to the AntsCanada Hybrid Nest Series.

Moderator: ooper01

Post Reply
antnewyork
Posts: 1
Joined: Sun Mar 25, 2018 4:13 pm
Location: 11215

How to Connect AC Tubing to Hybrid Nest?

Post: # 35102Post antnewyork
Sat Apr 14, 2018 12:09 pm

Hi All!

We are new to the AntsCanada community. We ordered a tetramorium Hybrid nest along with an outworld. Tubing and various fittings were included. We've figured out how to connect the AC tubing to the outworld, but we cannot figure out how to connect the tubing into the hybrid nest entrances. The small diameter tubing is too big to fit in the entrance holes. It seems there should be an attachment piece that connects tubing to the nest but none came in the shipment. And we can't find any online instructions or tutorials on how this is done.

Any suggestions or advice would be greatly appreciated as we have a queen and her colony on the way!

Best,
Molly

User avatar
PenguinAntKeeper
Posts: 35
Joined: Mon Jul 31, 2017 3:40 pm
Location: Toronto, ON

Re: How to Connect AC Tubing to Hybrid Nest?

Post: # 35110Post PenguinAntKeeper
Sun Apr 15, 2018 10:02 am

Try this: Moisten the tube in warm water to make it softer, then attempt to squeeze the tubing into the hole. If this doesn't work I don't know what else you could do
Hibernating: (all)

Parasitic Lasius:2

Founding:
Tetramorium Immigrans:2

Colonies:
Tetramorium Immigrans:1
Formica Spp:3

I'm new to ant keeping so my colonies are all still in test tubes. :roll: :?

User avatar
idahoantgirl
Posts: 1497
Joined: Sat Sep 12, 2015 11:52 am
Location: Idaho, USA

Re: How to Connect AC Tubing to Hybrid Nest?

Post: # 35112Post idahoantgirl
Sun Apr 15, 2018 1:34 pm

Mine fits ok, but it does need some elmers glue to hold it in.
Proverbs 6:6-8

Go to the ant, you sluggard;
consider its ways and be wise!
It has no commander,
no overseer or ruler,
yet it stores its provisions in summer
and gathers its food at harvest.

Keeping Tetramorium immigrans, Tapinoma Sessile

User avatar
ooper01
Head Moderator
Posts: 775
Joined: Sun Jul 26, 2015 1:07 am
Location: Utah, USA
Contact:

Re: How to Connect AC Tubing to Hybrid Nest?

Post: # 35119Post ooper01
Sun Apr 15, 2018 5:26 pm

The four entrances/exits on the Hybrid Nests V2 have 3 sized openings. The largest of the three is where test tubes fit. The next opening inside the outer hole is where the large poly tubing fits and the last inner hole is where the small poly tubing fits. The poly tubing holes are meant to be a tight fit to avoid disconnects. You may need to twist it back and forth a little to get it to go in.
~ ooper

Forum Moderator
Image

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests