Page 1 of 1

Help!! Ants not moving into new setup

Posted: Tue Sep 11, 2018 6:50 pm
by Diamondking
Hi, so I recently got a colony of Lasius Neoniger ants. There is a queen and three workers. Their test tube is very moldy and the water is almost completely gone. I have tried many ways to get them to move, like taping tubes together. I tried putting their old test tube on a portal, with another, dark tube on as well. The queen and the ants seem robot care about light, inclines or anything else. They made the new, clean tube a trash area, and when I added a third tube, they made that one the graveyard. I really don’t know what to do about this and I’m hoping you guys could help. Thanks!

Re: Help!! Ants not moving into new setup

Posted: Tue Sep 11, 2018 11:21 pm
by idahoantgirl
How long have you been trying?

Re: Help!! Ants not moving into new setup

Posted: Wed Sep 12, 2018 7:09 am
by Diamondking
3 days now

Re: Help!! Ants not moving into new setup

Posted: Wed Sep 12, 2018 10:24 am
by idahoantgirl
It can take up to a week. Be patient.

Re: Help!! Ants not moving into new setup

Posted: Wed Sep 12, 2018 2:09 pm
by Diamondking
Ok

Re: Help!! Ants not moving into new setup

Posted: Thu Sep 13, 2018 2:45 am
by Darkhero0987
Mine took over a month to decide to move even with a vary dirty test tube just keep one on and leave it it may take a few weeks if you notice they aren't moving with the light you can try to use heat as well just be vary careful not to hurt or cook the brood, works, or most importantly queen, use a low watt heating cable or pad ment for reptiles

Re: Help!! Ants not moving into new setup

Posted: Thu Sep 13, 2018 7:09 am
by Diamondking
I add two different tubes for them to move in to, but they made those trash and graveyards