Page 1 of 1
Hybrid 2.0 caps
Posted: Sun May 26, 2019 12:04 am
by zohawn
I have a hybrid 2.0 and the caps, the end pieces that have tiny holes in them, can fall out of the nest. How do I stop this?
Re: Hybrid 2.0 caps
Posted: Wed May 29, 2019 9:48 am
by ooper01
zohawn wrote: ↑Sun May 26, 2019 12:04 am
I have a hybrid 2.0 and the caps, the end pieces that have tiny holes in them, can fall out of the nest. How do I stop this?
Never seen this. The plugs fit snugly into the Hybrid entry/exit holes on all Hybrids I have tested. Which Hybrid Nest do you have?
Re: Hybrid 2.0 caps
Posted: Mon Jun 03, 2019 2:49 pm
by zohawn
Formica hybrid 2.0
Re: Hybrid 2.0 caps
Posted: Mon Jul 08, 2019 9:54 pm
by ooper01
Is it the old-style 3D printed Hybrid?
Re: Hybrid 2.0 caps
Posted: Tue Jul 09, 2019 8:16 am
by Hawkeye
zohawn wrote: ↑Sun May 26, 2019 12:04 am
I have a hybrid 2.0 and the caps, the end pieces that have tiny holes in them, can fall out of the nest. How do I stop this?
I don't have any experience with that particular nest, but I might have a quick solution. You could apply some very thin tape to the plugs like the stuff plumbers use to make sure fittings are snug and watertight.